Артикул
Каталог |
Наименование |
Описание |
Производитель
№ модели |
15F509
Grainger |
 |
Concrete Resurfacing, Patch and Repair, Self Leveling, Size 40 lb + 1 quart, Practical Square Feet 40 @ 1/8 In., Flash Point Greater than 212 Degrees F, Temp. Range 40 Degrees to 90 Degrees F, Traffic Hours 4-5 hr. @ 72 Degrees F, 1 hr. @ 72 Degrees F Setting Time, Adheres To Concrete, Use To Quickly and Easily Level Floors and Perform Horizontal Repairs. May Be Used As An Underlayment Or Wear Surface., Dries to A Durable, Hard Finish, Color Gray, Yield Strength Exceeds 6000 psi |
JET
GRA-410 |
15F536
Grainger |
 |
Concrete Resurfacing, Patch and Repair, Original Mix, Size 50 lb, Practical Square Feet 50 @ 1/8 In., Flash Point Nonflammable, Noncombustable, Temp. Range 40 Degrees to 90 Degrees F, Traffic Hours 6-8 hr. @ 72 Degrees F, 1 hr. @ 72 Degrees F Setting Time, Adheres To Concrete, Use To Resurface, Patch and Repair Concrete From Featheredge To 1/4 In. Thick., Dries to A Durable, Hard Finish, Color Gray, Yield Strength Exceeds 4000 psi |
JET
GRA-103 |
18F185
Grainger |
 |
Slip Roll Floor Stand, 24 In |
JET
S-24N |
18F186
Grainger |
 |
Slip Roll Floor Stand, 36 In |
JET
S-36N |
18F187
Grainger |
 |
Slip Roll Floor Stand, 50 In |
JET
S-50N |
18F188
Grainger |
 |
Metalworking Lathe with Stand, 3/4 HP |
JET
BD-920W |
18F190
Grainger |
 |
Bench Lathe with Stand, 2 HP |
JET
GHB-1440A |
18F191
Grainger |
 |
Metalworking LatheM 2 HP |
JET
GHB-1440A |
18F192
Grainger |
 |
Stand For Jet Hammer Drill, For Use With JET Mill Drill 18F193, 18F194, 18F195 |
JET
CS-18 |
18F193
Grainger |
 |
, Swing 14-1/2 In., Motor HP 1 HP, 1 Phase, 115/230 V, 110-2, 580 RPM, Chuck Size 1/2, Spindle Taper R-8, Spindle Speed 12, Spindle to Table 15 In., Column Dia. 3-5/8 In., Quill Dia. 2-7/16 In. |
JET
JMD-15 |
